al
uvac_threshold_dual
uvt2
Trendsetter_NEWS
The uvac_threshold_dual parameter specifies the minimum allowable unload vacuum
sensor reading required for the firmware to consider that two plates are being held
by the unload table vacuum cups.
The TABLE command will display the vacuum sensor reading and indicate whether it
is above or below the threshold specified by uvt2. If the vacuum level is greater
than uvt2, "two plates" will be displayed for the "vac threshold". If the vacuum
level is less than uvt2, "one plate" or "low" will be displayed. The al uvs parameter
is used to enable or disable the unload vacuum sensor. If the sensor is disabled, then
the full delay specified by aldly vac is used while waiting for vacuum to build.
byte
400
0 to 1023
This parameter should be set according to the following formula. Typically, the
default value will be very close to this already.
uvt = (V2p - V1p)/2 + V1p
uvt = uvac_threshold.
V2p = vacuum reading with vacuum turned on and two plates on the cups.
V1p = vacuum reading with vacuum turned on and one plate on the cups.
cfg